Field help (PURDPJT)

The management rules of this field are based on the PJTSNGDOC - One project by document- parameter (TC chapter, MIS group).

• When this parameter is set to Yes, the management of multiple projects is prohibited.
  The project code of the document line is never available for entry. In direct creation, it is loaded automatically with the code entered in the header and cannot be modified. In case of a document conversion, it is loaded with the project code of the lines of the selected document and cannot be modified.
  Additional lines must have the same project code. In case of line addition, the picking lists are automatically filtered so that only the documents with the same project code are displayed.
  If you modify the document header project code, this code is automatically used on the lines.
  
• When this parameter is set to Yes, the management of multiple projects is authorized.
  The project code of the document line is initialized with the header code and in case of document transformation, with the code of the selected document lines. The following lines can have a different project code.
  You can only modify the project code of lines if entering this field is authorized by the chosen entry transaction.
  
  If you modify the header project code, a dialog box opens and suggests to transfer this code to the lines of the document, according to the following options:
  • Yes: the project code is transferred to all lines.
  • No: the project code is not transferred to the lines.
  • Yes if same value: the project code is only transferred to the lines associated to the former project code.
  
  In modification mode, the project code management depends on the value of the CTLOPPCOD - Mandatory projectcontrol parameter.
• When the value is No, it may be a code selected freely.
• When its value is Yes, an existence check is systematically applies to the entered project code.
  You can use the Selection icon to display the list of available project codes.

When an analytical dimension type is used for the Project management tracking, then any modification of the project code made at header level will be redistributed to the lines; if the modification applies to a document line, then the dimension code of the dimension type will be reset. This reinitialization is compliant with the Default dimensions setup.