Safe X3 Web Server
Loading a "Safe X3 Web Server" component
To load the Web component, activate the SAFE X3 Web Servers selection panel and click the Add button.
For more information on the loading dialog box of a component, view the documentation on the parameter entry component
The Console acquires the various Web parameters and loads the component. Its parameters are displayed on the right hand side of the page.
The component status is Idle. Once configured, this value will move to the Active status.
Safe X3 Web Server configuration
To launch the actual configuration of the Web presentation server component, click the Configure button.
On exiting the configuration, the component status is Active, and the 'Adonix_web_Default’ service is created and launched.
The Web server is configured. You now need to publish the solution.
Solution publication
Configuration of the Apache server of the application server
The prerequisite to the publication of a solution is the configuration of the Apache server of the solution. To configure the Apache Server of the application server, follow these steps:
1. Enter the "Apache installation path" parameter located on the Application server in the solution management screen.
2. Click the Web publication button to launch the HTTP server configuration of the application server.
If no value is submitted, there is no need to proceed with the publication. It is absolutely necessary to solve the problem linked to the installation of Apache on the server..
It is possible to check the configuration of the HTTP server by launching Internet Explorer and the following URL: http://[servername]/[AliasOfTheSolution]/DOSB/GEN/FRA/FENW/FUSER.xml.
Note: the publication alias is in the form of 'Adonix_NameOfTheSolution'. Match case.
Solution publication
To publish the solution, follow these steps:
1. Select the Publications tab of the Safe X3 Web Server component.
2. Click the Add button and select the name of the solution to be published.
Update
To update the Safe X3 Web Server, follow these steps:
1. Stop the services of the Safe X3 Web Server via the console in the Administration tab of your server.
2. Install the update (check out the installation procedures for further information) in order to replace your version with the new one.
3. Refresh the configuration screen of your Safe X3 Web Server in the console. The update should be automatically detected by the console.
4. Click the Configure button to complete the update.
5. Check that the services have been correctly restarted following the configuration.