Apply link qty rounding
This parameter is used in the Cost calculation functions.
It indicates, during the component quantity calculation, if a rounding must be applied to those quantities:
Two values are available:
- No, no rounding applied.
- According to the BOM: roundings are carried out according to the BOM setup.
Example :
Let an end product "ED" and a BOM with two components: CPN1 and CPN2
For 100 EDs, the BOM is as follows:
- CPN1: quantity = 77. Lower rounding and 1 decimal unit.
- CPN2: quantity = 120. Rounding to the nearest and unit with no decimals.
According to the value of this parameter, when applying the calculation to 1 ED, the component quantities will be as follows:
Parameter value |
| CPN1 | CPN2 |
No |
| 0.77 | 1.2 |
According to the BOM |
| 0.7 | 1 |
Level of localization/Global variable
This parameter is defined at the level Site.It belongs to Chapter GPA (Manufacturing) and the Group COS (Costs),The following parameters are also associated with this chapter and group :
- CLCBUDRAT (Dimension rate selection bud C)
- CLCCUTRAT (Dimension rate selection act C)
- CLCSIMRAT (Dimension rate selection sim C)
- CLCSTDRAT (Dimension rate selection std C)
- CLCWOCAUT (Auto provisional costs)
- CSTRCPORD (Provisional cost declaration)
- EFFCSTUSE (Efficiency/cost considered)
- MFCRATCPL (Actual PC dim rate selection)
- MFCRATEXT (Expected PC dim rate selection)
- OPRRATE (Labor rate selection)
- OVECOLBUD (Budget calc overhead column)
- OVECOLCUT (Updated calc overhead column)
- OVECOLMFC (PC calc overhead column)
- OVECOLSIM (Simulated calc overhead column)
- OVECOLSTD (Standard calc overhead column)
- SCAMAJ (Material loss increase / costs)
No global variable is associated with it.
Functions concerned
The following functions are associated with this parameter :
Costing > Cost calculations > Budgeted cost calculation
Costing > Cost calculations > Revised cost calculation
Costing > Cost calculations > Simulated cost calculation
Costing > Cost calculations > Standard cost calculation