General parameters > Chapter Manufacturing > Parameter SCAMAJ (Material loss increase / costs)
Material Loss Increase / Costs
This parameter is used in the Provisional cost calculation function (standard, revised, budget and simulated).
- If this setup is set to YES, the cost calculation takes into account the reject percentage carried by the BOM link in the component quantity calculation.
- If not, only the net quantity is considered.
Level of localization/Global variable
This parameter is defined at the level Site.It belongs to Chapter GPA (Manufacturing) and the Group COS (Costs),The following parameters are also associated with this chapter and group :
- ARRQTYCPN (Apply link qty rounding)
- CLCBUDRAT (Dimension rate selection bud C)
- CLCCUTRAT (Dimension rate selection act C)
- CLCSIMRAT (Dimension rate selection sim C)
- CLCSTDRAT (Dimension rate selection std C)
- CLCWOCAUT (Auto provisional costs)
- CSTRCPORD (Provisional cost declaration)
- EFFCSTUSE (Efficiency/cost considered)
- MFCRATCPL (Actual PC dim rate selection)
- MFCRATEXT (Expected PC dim rate selection)
- OPRRATE (Labor rate selection)
- OVECOLBUD (Budget calc overhead column)
- OVECOLCUT (Updated calc overhead column)
- OVECOLMFC (PC calc overhead column)
- OVECOLSIM (Simulated calc overhead column)
- OVECOLSTD (Standard calc overhead column)
The global variable GSCAMAJ is associated with it.
Functions concerned
The following functions are associated with this parameter :
Stock > Inquiries > Stock > Trial kitting
Costing > Cost calculations > Budgeted cost calculation
Costing > Cost calculations > Revised cost calculation
Costing > Cost calculations > Simulated cost calculation
Costing > Cost calculations > Standard cost calculation