Reports > Module Geode GX > Report OP (Pick Order) 

This document is used to perform the preparations of packed or unpacked DOs.

It mentions the picking addresses and the quantities to be picked determined by the system upon wave launching.

The PO is composed and printed according to the preparation mode of the DO and according to the preparation areas where the picking operations need to be carried out.

The printer used is the one that has been set up in the preparation areas. The POs are sorted by travel sequences if they are set up, otherwise by store and addrress.

Prerequisite

Access to the report

This report can be accessed from the report menu of the group Outputs.

It is also called by default from the following functions :

 Outputs > Waves > Waves

List of criteria

Parameter

Parameter title

Type

site

Site

FCY

deposant

Depositor

DEP

vacation

Wave no

VAC

subnum

Wave Sub No.

SVC

opdeb

PO limit

PKP

tzone

All pick zones (Local menu No, Yes)

M1

zoneprepa

Preparation area

PKZ

toumvt

All movements (Local menu No, Yes)

M1

impselections

Print selections (Local menu No, Yes)

M1

Comments

In a start/end range type of parameter, not entering anything for the two values means that the report will ne be restricited to the parameter value.

Description of the report

The OP report header displays the following information:

  • The site and depositor
  • The wave no.
  • The date and time of the preparation launch
  • PO type: Picking, Reserve, Mixed
  • DO no.: in case of single-DO PO
  • Preparation area: in case of single-preparation area PO

For each line of the PO, a regrouping is made by Store and address, DO no. and DO line no., Reservation code, Lot no., Support no., code of origin, stock nature, Quantity and Original item container, quantity and homogeneous container, Status.
Each line specifies the following information:

  • Picking store and address
  • Location type: Reserve or Picking
  • Line nature: if blank, normal nature, otherwise the mention Kit or component should be used. The lines of "Kit" type are for information only and do not have any picking address since the components associated with a Kit are printed together right after the Kit item; in that case, the sort by travel sequence or by store and address is short-circuited.
  • Quantity and container to be picked
  • Quantity and homogeneous container of the container to be picked.
  • Total CU to be picked: in the case of components of a kit, the number of components by kit is mentioned between brackets.
  • Characteristics of the object to be picked: reservation code, lot no., stock nature
  • DO information: DO no., DO reference
  • Parcel sequence: parcel sequence of the PO
  • Parcel no. Parcel no. to which the picking corresponds, entered in the case of a DO with packing