Default planner
The Sage X3 user code to be assigned as the default Planner (project manager) for an incidence of non-conformance.
This user must be approved for involvement in your Non-conformance management process as a project manager or 'planner'.
This user code can be overwritten with an alternative user code when raising or amending an incidence of non-conformance.
Level of localization/Global variable
This parameter is defined at the level Site.It belongs to Chapter TC (Common Data) and the Group NCS (Non-conformance),The following parameters are also associated with this chapter and group :
- NCSAPPROVE (Approver)
- NCSDEL (Delete non-conformance)
- NCSDOCCHG (Linked document changes)
- NCSDOCCRE (Non-conformance creation mode)
- NCSMULTIWO (Link prod tracking multiple WO)
- NCSPLANNER (Planner)
- NCSQADEF (Default QA manager)
- NCSQAMAN (QA manager)
- NCSROOPRO (Default process root cause)
- NCSROORES (Default resource root cause)
Its values are defined by the function Users.
This parameter can optionally be defined at both Folder(chapter TC, group NCS) level and Site (chapter TC, group NCS) level.
The Sage X3 user code assigned to this parameter at Site level takes precedence over the user code assigned at Folder level.
Example
Folder level, NCSPLADEF=User code 'QAM1'
Site NA01 (Site level), NCSPLADEF=User code 'QAM2'.
A new non-conformance raised for site NA01: 'QAM2' is assigned as the default planner;
A new non-conformance raised for all sites excluding site NA01: 'QAM1' is assigned as the default planner.
The same Sage X3 user code can be assigned at both Folder level and Site level.
Functions impacted
The following functions are associated with this parameter :
Non-conformances > Non-conformance management > Non-conformance
Activity codes
The following activity codes (sorted by type) are associated with the parameter :
NCS : Non-conformance
Comments
The Sage X3 user code you assign to this parameter and any alternative user code assigned to an incidence of non-conformance as a Planner must have their user parameter NCSPLANNER - Planner (chapter TC, group NCS) set to 'Yes'. This confirms they are approved for involvement in your Non-conformance management process as a planner.